The index finger works on fewer strings than you think
The switch from open chords to barre chords goes smoothly once you stop treating a barre as six strings pressed at once. Look at a full F at the first fret, 133211. The index finger lies across all six strings, yet it only has to sound three of them: the low E, the B and the high E. The A, D and G strings are fretted by the ring, little and middle fingers, so whatever the index does there is covered. In Bm x24432 the index does real work on just two strings, the A and the high E.
That count sets the order of this four-week plan. Week one trains an index finger that holds two neighbouring strings, in the small F. Week two keeps two strings but adds a full minor shape on top. Week three asks for three strings in the moving E shape and brings it down to F. Week four puts the changes on a click. Finger strength comes last: a stronger hand only lets you put up with a bad grip for longer, and that grip then locks in buzz, dead strings and a tense shoulder.
Practise in short blocks of five to ten minutes, five or six days a week. A long session with a tired hand rarely makes anything cleaner. After each block write one line: date, chord, tempo, clean repeats in a row, and the string that failed. A typical first-week line reads "small F, no click, 6 clean of 10, B string buzzes when the index flattens". The examples below follow one such log from the small F to an Am, F, C, G round at 80 bpm. If a week's goal is not there yet, stay on it for a few more days; the calendar gives each problem its own slot.
Week 1: two strings under the small F
Start with the small F, xx3211, played from the D string. The index finger presses the B and high E strings at the first fret, the middle finger takes the G string at the second fret, and the ring finger takes the D string at the third fret. The four notes are F3, A3, C4 and F4, so the chord is complete and already has the root in the bass. Only two strings depend on the index, which is the smallest barre you can play.
Rest your thumb on the back of the neck, roughly behind the index or middle finger. Do not clamp the neck with your palm and do not push the elbow out to the side. Roll the index finger slightly onto its edge, toward the thumb: the side of the finger is firmer than the soft pad, so the contact with the strings is often more even. A few millimetres of roll is enough; do not twist the wrist.
Each practice block looks like this:
- Form the shape without strumming and check that the shoulder is down and the hand is not squeezing.
- Play the four strings one at a time.
- Fix one unclear note, then play the whole chord with a slow downstroke.
- Let go for a few seconds and rebuild the shape from scratch.
Do not hold the chord for minutes to build endurance. Your goal is the position where the notes ring with moderate pressure. If the B string buzzes, slide the index closer to the fret or adjust its roll before you press harder.
The change into the small F from Am x02210 teaches more than the shape itself. In Am the index already sits on the B string at the first fret, so it stays put and only flattens to cover the high E. The middle and ring fingers swap strings: the middle moves from the D string to the G string, the ring from the G string to the D string, one fret higher. Practise that crossing slowly, because it is the same kind of move every barre change asks for later. The week is done when Em, Am and the small F, four even strums each at 60 bpm, go round three times with no dead string.
Week 2: the Am shape higher up
Now take a barre with the root on the A string: Bm x24432, then Cm x35543. This is the Am shape moved up the neck. In Bm the index sounds B2 on the A string and F#4 on the high E; the middle finger covers the B string at the third fret, and the ring and little fingers take the D and G strings at the fourth. The low E must stay silent: let the tip of the index touch it lightly and start your strum from the A string.
Place the index on its own first and check the five strings one by one, then add the other fingers. If you build the whole Bm at once, you cannot tell what muted a string: the barre, a finger of the Am shape, or the palm. Most often the culprit is the high E, which lies under the base of the index near the knuckle, where the finger is softest. Pull the elbow in a little so the finger lies straighter across the neck, and the base presses more evenly.
Change between Bm and Cm without a metronome until the fingers stop searching, then set a slow tempo and change on the first beat of each bar. The move is a one-fret slide of the whole shape, so it trains releasing pressure without losing the grip. In the sample log, week two ends with "Bm to Cm, 60 bpm, 3 clean rounds, high E dull on the first try of each block": good enough to move on, with a note on what to watch.
Week 3: the E shape moves down to F
Take the major E shape with the root on the low E string, starting with A at the fifth fret, 577655. The index lies across all six strings and sounds three of them: A2 on the low E, E4 on the B and A4 on the high E. The ring and little fingers take the A and D strings at the seventh fret, and the middle finger takes the G string at the sixth fret.
Do not force the sound with a thumb pressing so hard the skin turns white. The thumb only supports the hand; accuracy comes from the index, which should sit right next to the fret without lying on it. Place the other fingers on their tips so they do not touch neighbouring strings.
If the B string dies under the index, check where the crease of its middle joint falls. A crease is a small hollow, and a string sitting in it never touches the fret properly. Shift the whole index a millimetre or two along its length, toward or away from the floor, until the crease lands on the G or D string, which the other fingers cover anyway.
When A rings cleanly, slide the same grip down: G at the third fret, 355433, then F at the first, 133211. The stretch grows as you go. On a 25.5-inch scale the frets sit 36.4, 103.1, 162.5 and 215.4 mm from the nut for frets 1, 3, 5 and 7. So the index and little finger stand about 53 mm apart in A at the fifth fret and about 67 mm apart in F, roughly a quarter wider. That is why F feels like a different chord even though the shape is identical. If F falls apart, go back to the third fret, find the clean shape and repeat the short move down. Then try the reverse route, F to G to A, so that F stops feeling like a separate monster.
Week 4: chords that live in time
Link Am, F, C and G, four beats each. Set the metronome to 60 and play even downstrokes. One round is 16 beats, so at 60 bpm it lasts 16 seconds and three clean passes take under a minute. After three clean passes in a row, add 5 bpm. One or two clean passes out of three means stay at that tempo; none means drop back 5 bpm.
Here "clean" means two things: the change lands on the beat, and every string that should sound in the shape rings when you check it alone. Start lifting the fingers on the last beat of Am so F can land on the next downbeat. At 60 bpm that last beat gives you one second; at 80 bpm it shrinks to 0.75 seconds, which is why each tempo step needs its own three passes.
Two anchor fingers make the round easier. From Am to F the index stays at the first fret and only flattens into the barre. From F to C the ring finger stays on the A string at the third fret, because both chords use that note, C3. Keep those fingers in light contact with the string while the others move. The sample log reaches 80 bpm on day five of the week after two stalls at 70; a week that ends at 70 still counts, and the next one starts there.
Record one round on a clean sound; distortion hides weak strings, and a recording shows timing gaps you miss while playing. The chord change exercises and the DAW click test for timing are good next steps for this week.
Check the chord string by string
A loud strum is a poor judge of a barre: it blends the notes and hides a dead string. After every new placement, pick the strings slowly from bass to treble and back. The usual mistake is to hear noise and squeeze harder. The hand stiffens, accuracy drops, and after a few minutes fewer notes ring. Change one thing at a time instead: index position against the fret, its roll, thumb position or elbow height.
Mild fatigue after practice is normal. Pain in the hand, fingers, forearm or shoulder means stop, rest and come back to a shorter block.
Before you raise the tempo, check four things:
- the shape forms without a jerk of the shoulder or a bent wrist;
- every string that should sound rings on its own;
- the strings that should be silent are silent;
- three rounds of the progression land on the beat at this tempo.
If F is still quiet after a month
A and Bm clean higher up while F at the first fret still needs a lot of force is a common place to be at the end of four weeks. Part of the reason is geometry. String tension is the same along a tuned string, but pressing a string close to the point where it is held takes more force for each fraction of a millimetre. In a simple string model the force grows with tension times depth times (1/a + 1/b), where a and b are the distances from your finger to the nut and to the saddle. With the finger just behind the first fret, a is about 33 mm; behind the fifth fret it is about 159 mm. Take an illustrative string height of 0.5 mm over the first fret and 1.1 mm over the fifth: the first-fret note still needs about 1.7 times the force. Raise the first-fret height to 0.9 mm with a nut that is cut too tall, and the figure climbs to about 3 times.
That is the difference between a hand that needs more practice and a guitar that needs a nut job. If the higher positions are clean and the first fret is not, even with careful placement, check the nut with the open-string test in buzzing strings: your hand or the guitar before adding another hundred repetitions. If the nut checks out, go back to the small F, then the full E shape at the second or third fret, and move down one fret every few days. The log will show the day F joins the round at the same tempo as the other three chords.